calibration result
1.The calibration result is consistent with that of physical research institute (PTB) of Deutschland.
2.The differences between its clinical use and calibration may cause the measurement result to be not accuracy enough.
4.The analysis conditions are optimized by measuring the contents of metallic element in aluminum alloy by applying Finland ARC-MET 930 metal analyzer and making universal calibration curve and the precision and accuracy of analysis result are also discussed.
5.In this work, p-chloropheno1/chloroform mixed solvent is used to dissolve PA 6 and PET sam ples, MWD determinations are carried on seperately with shodex A804 column and RI detector in the same solvent, the MWD calculation of PA 6 and PET is accomplished using the Kηvalue calibration method of broad distribution sample a satisfactory result of experiments is obtained.
6.Result: The calibration curve was linear within a range of 10.05-200.92μg·ml~(-1)(r =0.999 9) , and the average recovery was 99.73% , USD = 1.57% (n =6).
7.Result The calibration curve was linear at a range of 20~120 μg/mL for paeoniflorin(r=0.999 4). The average recovery was 99.79% and RSD was 1.52% (n=6).
8.Abstract: The principle of reproducing the standard with interference measuring method is presented,the test metrology result has been analyzed and the new calibration system is introduced in this paper.
9.Result of calibration shows that piezoelectric characteristic of PVDF(5 mm×5 mm) is linear if the pressure is lower than 150 MPa. Piezoelectric coefficient of PVDF is about 20 pC/N after the calibrated data fitting.
10.The result was showed as follows: calibration on curves for Ala-Gin was linear from 6.25 to lOOmmol/L; linear formula is Y=28186X-9905.1,r=0.9997and CV was 5.33%; The recovery was 98%.
