catalytic conversion
1.CATALYTIC CONVERSION OF METHANE OVER MoO_3/HZSM-5 CATALYST UNDER NON-OXIDIZING CONDITION
2.Decomposition of a chemical compound by reaction with water, such as the dissociation of a dissolved salt or the catalytic conversion of starch to glucose.
3.The experimental results showed that the percent catalytic conversion of NOx in analog flue gas reach 93% when the airspeed is 18000h-1.
4.The influence of rare earth Cerium (Ce) on the structure and properties of automotive emission catalyst LaMn and washcoat materials y -Al2O3 was studied by means of XRD, SEM, BET, and catalytic conversion measurement, and so on.
5.In the two-phase catalytic system, we realize the conversion of proper nitriles to alcohols and α,β-unsaturated nitrile to saturated nitriles accordingly.
6.With a reacting gas mixture of 530 ppm NO, 650 ppm C2H4, 5.8% O2 in N2 and GHSV = 12000 h-1, the pure catalytic, pure plasma-induced and plasma-catalytic (in the POC reactor) NOx conversion percentages are 39%, 1.5% and 79%, respectively.
7.It was studied by XRD、DTA、TGA、BET and applied to oxidation dehydrogenation of C_3H_8 with CO_2 to C_3H_6 .The best catalytic activity result, that is propane conversion rate of 23.3% and propene selectivity of 80.1%, could be attained with the sample n(Cr)∶n(Mg)∶n(Al)=(1.25∶2∶1).
8.In comparison, the crosslinked polymeric Salen-Ti(IV) exhibited good catalytic activity in this reaction. Also, the catalyst with the 0.5 /100 degree of crosslinking showed the best catalytic activity, and up to 88 % ee with 95 % conversion was obtained in the asymmetric trimethylsilylcyanation of 4-fluorobenzaldehyde at 1 mol % of catalyst loadings.
9.Heterogeneous catalytic oxidation reactions of n hexane and n heptane were performed in CSTR to investigate the catalytic activity of VO(pic) 2 NaY under continuous operation. The conversion was calculated and the effect of different operation conditions on oxidation of alkanes was discussed.
10.The technique of H_2S selectivity catalytic oxidation has many advantages such as low cost, simple technology, easy operation and high conversion rate.
