1.This results in a fourfold increase of heat (Correspondingly,heat drops by 75% if current density is reduced by half, e.g. by doubling the effective electrodecontact area.
2.XRD results indicate that LSM has no reaction with CBO at 1000 ℃ in air. SEM results show that the composite electrode formed good contact with Ce_(0.9)Gd_(0.1)O_2 (CGO) electrolyte after sintered at 900 ℃ for 2 h.
3.The intention of the paper is to study the deposition and properties of ZnTe(ZnTe:Cu) polycrystalline thin films and to apply ZnTe(ZnTe:Cu) as a complex back contact layer between CdTe and metal electrode to obtain ohm contact and high efficiency CdTe solar cells.
4.Ti/Cu/Ni/Au metal is introduced as the CPW electrode material,and good contact with Ta_2N thin-film is guaranteed accordingly. Therefore,the typical reflection coefficient of the submount is reduced to be lower than-21 dB up to 40 GHz.
6.The running voltage of smelting furnace is about 140 volt, and electrode current is as high as several thousands ampere. The contact technology and the control exist much difficult problem when the reactive power compensation is used to so large current.
7.If you were to leave a grounded cable stationary in an energized high-frequency electrode for a while, you would notice that the insulation is noticeably warmer where it made contact with the corona field.
8.The design and improvement situation are summarized on contact clamp, electrode holder, low hood structure, furnace charging system and great current system.
10.It can improve the contact characteristics of a Si TFTs and use as a good source and drain electrode material of double redundant structure with Mo and Al.
