isolation parameters
1.According to a quantitative analysis, concludes that the matching relationship between air changes and cooling load is a major factor in determining the actual temperature difference and isolation coefficient, and that the parameters in isolation ward would play a dominant role.
2.dB vibration isolation at the vibration frequency, and the controller parameters adjustment is fast.
3.Change of purification affected by different parameters of Sepharose FF chromatography in isolation of AP Ⅲ
4.Vibration acceleration transmissibility from hull board side to plate of the platform was formulated. Passive parameters are important to vibration control performance of the vibration isolation system.
5.Based on the analysis of engineering cases, the seismic response characteristics are studied systemically and the optimal base-layer parameters of a typical R-FBI(resilient-friction base isolation) structure are discussed.
6.Abstract: In this paper,for the brick structure with frame-shear wall in the first story,the principle of determining the parameters of a laminated rubber bearing such as stiffness,yield strength and axis press stress was discussed;and the vibration-isolation effectiveness was tested by analyzing a representative project using nonlinear time-history analysis method.Some suggestion was made to design and analyze brick structure with ground frame-shear wall on rubber vibration-isolation system.
7.This paper presents firstly eight technical parameters which measure the effectiveness of the automatic test equipment (ATE). They are fault detection rate (FDR), fault isolation rate (FIR), fault detection accuracy (FDA), test time (td), fault detection probability (Pd), fault missing probability(Pm), false alarm probability (Pf) and fault resoonluti (δ).
8.The design theory and fabrication technique of the optical circulator with pris-matic polarizing beam splitter and its applications in the fibre communication and sensingsystems are presented in this ljaper The parameters of the optical circulator fabricatedhave been measured with an insertion loss less than 2.8dB,isolation ratio greater than 25dBand echo-wave loss greater than 40dB, The characteristics of the device are insensitive tothe polarication of the input light
