爱词霸英语   汉语   手机版   软件版下载 | English
每日一句:正在加载...
1.Experiment of the influence of outlet velocity on comfort in multi-point jet zone
风速对多点射流区域舒适性影响的实验研究收藏指正
2.The flow feature of liquid phase on CTST was obtained. The results indicate that the velocity of liquid phase on the plate increases with the intensity of overflow and decreases with the increase of the height of outlet weir. The effect of the gas rate of tray holes on the velocity distribution of liquid phase is less than the other factors.
实验得出立体传质塔板板上液相流动的特性,结果表明:板上液相速度随溢流强度的增大而增大,随出口堰高的增加而减小,板孔气速对板上液相速度分布的影响最小,随着板孔气速的增大,板上液相流动速度只是在罩间略微增大。收藏指正
3.This paper analyzes the whole three-dimensional viscous flow from the inlet to the outlet including the impeller, stay vane and the syphon, acquires the flowing properties such as pressure and velocity distribution and the property-curve of the pump, and the vortex distribution and hydraulic loss.
本文针对太浦河泵站斜 1 5°轴伸泵 ,进行了水泵装置从吸入口至出口包括叶片、导叶、弯管段等在内的整体三维粘性流动分析 ,得到了流道内部不同工况下的流动特性如压力、速度分布规律及泵特性曲线 ,以及流道内部的旋涡分布和水力损失情况。收藏指正
4.The results show that when spray is introduced,the uniformity of gas velocity improves greatly,the max velocity in the outlet section changes from 12 m/s to 6 m/s.
模拟结果表明,引入喷淋液后,出口截面气速分布明显均匀化,其最大值由无喷淋时的12m/s降至6m/s。收藏指正
5.Obtained temperature field and velocity field and concentration field in the gasification furnace, in addition achieved coal gas component on outlet.
总结了在具有复杂化学反应的高温、高压容器中,对水煤浆气化过程的数值模拟时经常遇到的问题和解决方法。收藏指正
6.The annular diameter, bore, maximum flow and gradient of pulmonary artery (PA) and the flow velocity of right ventricular outlet tract (RVOT) were measured.
PBPV 术前后均作ECHO 及心导管检查,测量肺动脉瓣环(PVAD),肺动脉瓣(PV) 开放口径,PV 最大血流速度Vmax 及压力阶差ΔP,右室流出道(RVOT) 血流速度,并作对照分析。收藏指正
7.On the basis of the judgement criterion of HITACHI offering that the velocity taking the soil grain which diameter is smaller than 75umor is 75um needs 0.08m/s, based on it, judging whether the velocity near the outlet is rational.
根据日立公司提供判断准则:携带直径小于等于75μm的土颗粒需要的速度大小为0.08m/s,由此来判断出水口附近速度是否合适。收藏指正
8.The influence of variable parameters, such as, die geometry, material capability and operating condition parameters, on pressure profile, velocity profile and uniformity of material in outlet of die were also analyzed and discussed.
并分析讨论了当机头的几何要素、胶料物性和工作参数等各种参数改变时对螺杆分配机头内部压力场和速度场的影响以及对机头出料均匀性的影响。收藏指正
9.The author of the paper preliminarily inquires into the effect of gas velocity, superficial liquid velocity, static bed height, density of packing ball, and the area of a single packing ball surface on the pressure drop across the bed, height of bed expansion, outlet co_2-content, desorption efficiency, and the mass transfer coefficient K_L.
本文初步探讨了气体速度、喷淋密度、床层静止高度、填料球密度,单个填料球表面积对三相流化床除co_2器的床层压降、床层膨胀高度,出水CO_2含量、脱吸效率、传质系数K_L值的影响。收藏指正
10.Under the different agitating velocity and agitator vertical location,the effect of agitator on the feed powder characteristics and the fluidizing stability of system was analyzed in dense phase pulverized coal pneumatic conveying,the new correlations of different parameters with average feed powder rate and bed pressure standard deviation were established,the optimal operation and geometrical parameters were provided with 90 r/min agitating velocity and location of +25 mm comparative to powder outlet.
在不同搅拌转速和搅拌器垂直高度下,分析了搅拌器对浓相煤粉气力输送中给粉特性和流化稳定性的影响,建立了各参数与平均给粉速率及罐压标准偏差之间的关联式,获得了搅伴器的最佳操作参数和结构参数:搅拌转速为90 r/m in,搅拌器相对出粉口中心位置为+25 mm.收藏指正
尝试查询
汉英释义