programmed computer
6.The modelling experiment programmed with TRUBASIC has been carried out on a computer WYSE-386 and verified by warrick laboratory tests.
7.The electric circuit of hardware of speedometer’s drive-model in driving training simulator is designed, and the control program of single chip is programmed, finally software of COM port communication between computer and single chip is programmed by using VC++, so that speedometer can be driven.
8.In the condition of small angle of attack we assume that the combination and its image are both parallel to the ground. The calculation procedure is programmed in ALGOL-60 Language on an electronic computer(TQ-16). Some typical results given by this method are included in this paper.
9.The AGC (Automatic Gauge Control) System in the four stands of BenXi tandem cold mill is programmed by block programming language, P80i and LCR1600, and run in HPCi industrial computer and JS1600 computer.
10.The algorithm has been programmed in PASCAL language and implemented on a VAX 11-780 computer in University of California, Berkeley. Experimental results are quite encouraging.
